Custom Garage Cabinets in Baytown, TX

How a Baytown project runs

1. Measure cars and clearances. We measure the garage, your vehicles, door swings, garage door tracks, water heater and electrical panel. These clearances set the maximum cabinet depths along every wall.
2. Plan the zones. We group storage by use: workbench and tools, sports and outdoor gear, cleaning supplies, chemicals and seasonal bins. You review a drawing with sizes, doors and locks.
3. Select materials and finish. You choose finish colors, hardware and work-surface materials. We recommend finishes and hardware that handle heat, humidity and scrubbing in a non-conditioned space. We explain the tradeoffs of each.
4. Build and seal in the shop. We build the cabinets from plywood in our Houston shop and seal every face and edge before delivery. Doors and drawers get stainless or coated hardware where helpful.
5. Install on cleats or legs. The crew mounts cabinets to studs on French cleats or sets them on adjustable legs, levels everything on the sloped slab and adjusts doors before the final walkthrough.

Local conditions we plan for

Houston garages are not conditioned, so cabinets face high heat, high humidity and big temperature swings. Plywood with sealed edges and finishes rated for those conditions holds up much better than particleboard kits. Most garage slabs slope toward the door for drainage, so we level cabinets with adjustable legs or wall cleats rather than shimming against the floor. Storms can push water under the garage door, and some areas see flooding, so keeping boxes 4 to 6 inches off the slab is strongly recommended. We also keep clearances around water heaters, electrical panels and the fire-rated wall between the garage and house.

Houston humidity is the main thing we design around. Solid wood moves with the seasons, so we use furniture-grade plywood for cabinet boxes and shelves, and frame-and-panel doors that let panels float. Sink bases get extra finish protection, and in neighborhoods along bayous or in flood-prone zones we can raise toe kicks or use moisture-resistant materials on the lowest components. Keeping the house conditioned during installation helps everything settle in properly.

For general planning, a single wall of custom garage cabinets in Greater Houston often runs about $4,000 to $9,000, and a full two-car garage with a workbench, tall lockers and upper cabinets can range from $10,000 to $25,000 or more. These figures depend on size, materials and site conditions. We provide a written estimate after measuring your garage and vehicles.