Custom Kitchen Cabinets in Baytown, TX

How a Baytown project runs

1. Consultation and measure. We visit your home, talk through how you cook and store things, and take full measurements including ceiling height, window and outlet locations, plumbing stub-outs and appliance model numbers so the plan fits on the first try.
2. Layout and samples. You review a drawn layout with elevations and choose wood species, door style, finish and hardware from real samples. We confirm appliance clearances, filler widths and countertop overhangs before anything is cut.
3. Shop fabrication. Boxes, face frames, doors and drawers are built and finished in our Houston shop. Finishing indoors keeps dust and humidity under control and gives a harder, more even coat than spraying in an occupied home.
4. Installation. Our crew removes old cabinets if needed, shims bases level on the slab, fastens boxes to studs, scribes fillers and panels to the walls, and sets doors, drawers and hardware. Countertop templating follows once the boxes are locked in.
5. Final walkthrough. We walk the kitchen with you, adjust every hinge and slide, touch up any marks, and explain care for the finish. Anything that needs attention goes on a written punch list we close out.

Local conditions we plan for

Houston humidity is the main enemy of kitchen cabinetry. Particleboard boxes absorb moisture at the sink base and swell, while solid wood doors move with the seasons, so we use plywood boxes and five-piece doors that allow panels to float. Most local homes sit on slab foundations, and older slabs in 1960s neighborhoods often have a slight crown or dip, which we shim out so countertops sit flat. We leave proper ventilation gaps around dishwashers and refrigerators, and we finish all sides of sink bases. For coastal areas toward Galveston and League City, we recommend stainless or quality plated hinges and slides, since salt air can pit cheaper hardware within a few years.

Houston humidity is the main thing we design around. Solid wood moves with the seasons, so we use furniture-grade plywood for cabinet boxes and shelves, and frame-and-panel doors that let panels float. Sink bases get extra finish protection, and in neighborhoods along bayous or in flood-prone zones we can raise toe kicks or use moisture-resistant materials on the lowest components. Keeping the house conditioned during installation helps everything settle in properly.

As a general planning range, custom kitchen cabinets in Greater Houston often run about $500 to $1,200 per linear foot installed, so a typical 25 to 35 linear-foot kitchen may land between roughly $15,000 and $40,000. Your number depends on size, materials and site conditions, so treat this only as a starting point and get a written estimate after our in-home measure.