Custom Laundry Room Cabinets in Galveston, TX

How a Galveston project runs

1. Measure machines and utilities. We measure the room and your washer and dryer, then locate water supply, drain, dryer vent, gas line if any and outlets. These set where cabinets can and cannot go.
2. Plan the work flow. You review a layout that follows the laundry process: sort, wash, dry, fold, hang and put away. We place hampers, counters and rods in the order you use them.
3. Select finishes and counters. You choose cabinet color, hardware and countertop from real samples. We recommend moisture-resistant options for areas near the sink and machines. We also look at how each sample handles water spots and detergent drips.
4. Build and seal in our shop. We build plywood cabinets in our Houston shop, sealing every surface and lining the sink base, then finish them before delivery so they are ready for daily use.
5. Install and test clearances. The crew installs cabinets and counter supports, checks clearance around machines, vents and valves, and confirms the washer and dryer can be pulled out for service.

Local conditions we plan for

Houston laundry rooms combine high outdoor humidity with washer moisture and dryer heat, which is hard on cabinets. Sealed plywood construction and moisture-resistant finishes are important. Dryer vents should run the shortest path to the outside, and we never block or crush them behind cabinets. On slab foundations, moving machines or adding a sink means trenching concrete, so we work with existing plumbing whenever possible. A washer pan with a drain, or at least a leak sensor, is a good idea for upstairs laundry rooms common in newer two-story homes.

Salt air, high humidity and storm exposure define this county. We build with plywood boxes, sealed edges and finishes chosen for damp conditions, and we steer coastal homeowners toward corrosion-resistant hardware. In elevated homes, kitchens can see wider temperature and humidity swings, so stable door construction matters. For ground-level homes in flood-prone areas, we can plan raised bases and moisture-tolerant materials for the lowest components.

For general planning, laundry room cabinets with uppers and a folding counter in Greater Houston often run around $4,000 to $9,000, while larger rooms with a sink, tall storage and specialty pull-outs can range from $10,000 to $20,000 or more. These figures vary with size, materials and site conditions, so ask for a written estimate after we measure.