Custom cabinetry, trim & remodeling across Greater Houston Call (281) 660-3903 Text (832) 280-1608
Custom Laundry Room Cabinets in Bellaire, TX

Harris County · Storage & Organization

Custom Laundry Room Cabinets in Bellaire, TX

Custom laundry room cabinets make small Bellaire laundry rooms far more useful. Ace Kustoms designs and installs them throughout Harris County.

Custom Laundry Room Cabinets for Bellaire homes

Bellaire is a small city fully surrounded by Houston, southwest of the 610 Loop near the Galleria and Meyerland. It has its own city government and building rules, quiet residential streets and easy access to the Texas Medical Center. We work here regularly on both original homes and newer rebuilds.

Bellaire's original 1950s and 1960s ranch homes have largely been replaced by two-story new construction, but plenty remain. Older houses need full kitchen layouts and updated baths, while newer homes often want better closets, built-in offices and upgraded trim. Some streets have flooded in past storms, so raised bases in lower cabinets come up in conversation.

Newer homes in Bellaire usually have dedicated laundry rooms, sometimes upstairs, but builders often install only a single wire shelf. Homeowners ask us to add upper cabinets, a folding counter and a sink. Upstairs laundry rooms benefit from sealed cabinets and leak protection, and we plan around drain pans and shut-off valves so they remain reachable after installation. Done early, it avoids clutter.

Every project starts with an in-home measurement in Bellaire. We build in our Houston shop and the same crew handles installation, so the person you talk to at the estimate is accountable for the result. Learn more about our full custom laundry room cabinets service.

What you get with Ace Kustoms

Folding counter over front-loaders

A countertop installed above side-by-side front-load machines gives you a full-width folding surface where there was dead space. We leave clearance for vibration and set the height so the counter is easy to use.

Supplies off the floor

Upper cabinets and pull-outs hold detergent, stain removers, dryer sheets and cleaning supplies. Child locks or high storage keep pods and chemicals away from small children and pets. Pull-outs put everything in view.

Moisture-resistant construction

Sealed plywood boxes, finished interiors and a waterproof liner or sealed floor in the sink base protect against drips and leaks. Particleboard cabinets swell quickly when exposed to water in a laundry room.

Hanging and drying built in

A rod under the upper cabinets for hanging shirts straight from the dryer, plus a fold-down or pull-out drying rack for delicates. Clothes stay wrinkle-free and air-dried items have a dedicated place.

Popular options in Bellaire

Stacked machines with tall cabinet

A stacked washer and dryer beside a tall cabinet for brooms, the vacuum and an ironing board. Frees up wall space for a sink or folding counter in narrow rooms.

Laundry sink base

A deep single-bowl utility sink or an undermount sink in a counter, set in a sealed base cabinet with a waterproof floor liner. Handy for hand-washing, soaking stains and rinsing muddy items.

Hamper and sorting pull-outs

Double or triple pull-out hampers with removable bins, or tilt-out hamper doors. Sized for standard laundry bins and placed next to the washer for easy loading. Bins lift out so you can carry them to the machine.

Open shelving and cubbies

Open shelves for baskets and folded towels, or cubbies for each family member's clean laundry. Painted or stained hardwood shelves add warmth to a mostly white utility room. Baskets can be labeled.

Pantry shelving stocked with glass storage jars
White shaker kitchen with glass-front upper cabinets

How a Bellaire project runs

  1. Measure machines and utilities. We measure the room and your washer and dryer, then locate water supply, drain, dryer vent, gas line if any and outlets. These set where cabinets can and cannot go.
  2. Plan the work flow. You review a layout that follows the laundry process: sort, wash, dry, fold, hang and put away. We place hampers, counters and rods in the order you use them.
  3. Select finishes and counters. You choose cabinet color, hardware and countertop from real samples. We recommend moisture-resistant options for areas near the sink and machines. We also look at how each sample handles water spots and detergent drips.
  4. Build and seal in our shop. We build plywood cabinets in our Houston shop, sealing every surface and lining the sink base, then finish them before delivery so they are ready for daily use.
  5. Install and test clearances. The crew installs cabinets and counter supports, checks clearance around machines, vents and valves, and confirms the washer and dryer can be pulled out for service.

Local conditions we plan for

Houston laundry rooms combine high outdoor humidity with washer moisture and dryer heat, which is hard on cabinets. Sealed plywood construction and moisture-resistant finishes are important. Dryer vents should run the shortest path to the outside, and we never block or crush them behind cabinets. On slab foundations, moving machines or adding a sink means trenching concrete, so we work with existing plumbing whenever possible. A washer pan with a drain, or at least a leak sensor, is a good idea for upstairs laundry rooms common in newer two-story homes.

Houston humidity is the main thing we design around. Solid wood moves with the seasons, so we use furniture-grade plywood for cabinet boxes and shelves, and frame-and-panel doors that let panels float. Sink bases get extra finish protection, and in neighborhoods along bayous or in flood-prone zones we can raise toe kicks or use moisture-resistant materials on the lowest components. Keeping the house conditioned during installation helps everything settle in properly.

For general planning, laundry room cabinets with uppers and a folding counter in Greater Houston often run around $4,000 to $9,000, while larger rooms with a sink, tall storage and specialty pull-outs can range from $10,000 to $20,000 or more. These figures vary with size, materials and site conditions, so ask for a written estimate after we measure.

Custom Laundry Room Cabinets in Bellaire: FAQs

Can you put a countertop over my washer and dryer?
Yes, with front-load machines. We install a counter supported by cleats or side panels, not resting on the machines, with clearance for vibration and to slide the machines out for service. The height is set so you can open the doors and still fold comfortably.
Will wood cabinets hold up in a laundry room?
Plywood cabinets with sealed edges and finishes hold up well. The problem is usually particleboard, which swells quickly when wet. We seal every surface, line sink bases and keep cabinets off wet floors where possible. Hardware and finishes are also chosen to tolerate humidity and occasional splashes.
How high should cabinets be above the machines?
Upper cabinets typically sit 18 to 24 inches above the top of front-load machines or a counter. For top-load washers, we leave enough clearance for the lid to open fully. We check your machine's specifications before setting heights. Taller households sometimes prefer the lower end of that range.
Does Ace Kustoms work in Bellaire?
Yes. Bellaire is part of our regular service area in Harris County, along with nearby West University Place, Houston, River Oaks, Meadows Place. We schedule in-home measurements throughout the week and the estimate is free.
How do I get an estimate in Bellaire?
Call (281) 660-3903, text us, or send the form on this page with a few photos and rough measurements. We will set up an in-home visit, measure the space and follow up with a written, itemized estimate.

Planning guides

Free, no-pressure estimate

Get your free in-home estimate

Tell us about your kitchen, bath or built-in project. We usually reply within one business day.

  • In-home measurement and design consult
  • Written, itemized estimate — no hidden fees
  • Built in our Houston shop, installed by our own crew

Office hours: Mon–Fri 8:00 AM – 5:00 PM