Custom Stair Installations in Alvin, TX

How a Alvin project runs

1. Measure and inspection. We measure every rise and run, check stringers for soundness, look at the existing railing and note flooring transitions. We flag any code issues, such as uneven risers or missing handrails.
2. Design and selection. You choose wood species, stain or paint, nosing profile and any custom features such as a bullnose step or lighting. We confirm how the stairs will meet floors at the top and bottom.
3. Shop preparation. We cut and prepare treads and risers, build custom parts such as winders or bullnose steps, and pre-finish where it makes sense to reduce time on site.
4. Installation. Our crew removes old coverings, prepares the stringers, scribes and installs each tread and riser with adhesive and fasteners, and installs skirt boards, nosings and trim.
5. Finish and walkthrough. Site-finished stairs are sanded, stained and coated with a durable floor finish. We walk the stairs with you, check for squeaks and explain cure times before normal use.

Local conditions we plan for

Many Houston two-story homes have stairs built over a slab with a first riser that sits directly on concrete, and flooring changes on that slab often throw off the first step height. We measure and correct this so the first riser matches the rest. Humidity causes wood to move, so we acclimate hardwood treads in the home before installation and leave room for seasonal expansion at the skirt. Builder-grade stairs in the area are often built with stringers and pine or particleboard treads intended for carpet, which need inspection before hardwood goes on. Stairwell walls in two-story homes can be tall, so we plan scaffolding or ladders safely around them.

Much of Brazoria County is low, flat and close to the Gulf, so humidity and salt air are constant factors. We use plywood boxes, sealed edges and durable finishes, and we pay attention to hardware selection in homes near the coast where corrosion is a concern. For homes in flood-prone areas, raised toe kicks and moisture-resistant materials in the lowest components can make recovery easier after high water.

As a general planning range, a straight carpet-to-hardwood stair conversion in Greater Houston often runs about $150 to $350 per step for treads, risers and finishing, so a typical 14-step stair may land roughly between $2,500 and $5,500 before railing work. Curved stairs and custom parts cost more. Get a written estimate after an in-home measure.