Custom Trim & Millwork Installation in Richmond, TX

How a Richmond project runs

1. Consultation and measure. We measure each room, note ceiling heights, wall conditions and existing trim profiles, and discuss the look you want. We bring samples so you can compare sizes in the room.
2. Design and selection. You choose profiles, materials and finish. For wainscoting, accent walls or ceilings, we provide drawn layouts showing spacing and how details meet doors, windows and outlets.
3. Shop preparation. We mill custom profiles if needed, build beams, coffers or panels in our shop, and prime trim stock so installation and final painting go smoothly.
4. Installation. Our crew removes old trim if needed, installs blocking, then cuts, copes, scribes and fastens each piece. Joints are glued and pinned, and outlets are extended where trim depth changes.
5. Finishing and walkthrough. Nail holes are filled, joints caulked and trim sanded and primed or painted as planned. We walk each room with you and handle any punch list items before finishing.

Local conditions we plan for

Houston's humidity makes wood trim swell and shrink through the year, which is why poorly installed miters open up after the first summer. We cope inside joints, glue outside miters and use flexible sealants that move with the wood. Paint-grade MDF is stable in dry rooms but should be avoided in bathrooms, laundry rooms and near exterior doors, where we use poplar, finger-jointed pine or PVC trim. Slab floors in older homes are often uneven, so we scribe baseboard rather than relying on shoe molding alone. Exterior walls in older ranch homes may be out of plumb, which affects crown fit, so we use flexible blocking and careful scribing.

Fort Bend sits on flat, low ground along the Brazos River and its creeks, and humidity stays high most of the year. We use plywood boxes and stable door construction to handle seasonal swelling. For homes in areas that have seen high water, we can discuss raised toe kicks, moisture-resistant bases in laundry rooms and garages, and finishes that tolerate wipe-downs. Good ventilation in bathrooms protects vanity finishes over time.

As a general planning range, installed crown molding in Greater Houston often runs about $8 to $25 per linear foot, baseboard about $5 to $15 per linear foot, and wainscoting or board and batten roughly $25 to $60 per linear foot of wall. Coffered ceilings and beams are priced per project. Get a written estimate based on your rooms and materials.