Cabinets & Trim in Angleton, Brazoria County TX

Carpentry for Angleton homes

Angleton has many homes from the 1950s through the 1980s, often single-story ranch houses with compact kitchens, plus newer subdivisions and rural properties. Kitchen remodels that rework closed layouts, vanity updates and garage storage are common. Acreage homes also ask for mudrooms and shop cabinets.

Angleton is the Brazoria County seat, located on SH 288 roughly halfway between Pearland and Lake Jackson. It has the county courthouse, an older downtown and residential neighborhoods that spread out into farm and ranch land. The Brazosport cities and the coast are a short drive south, and Houston is about 45 minutes north on 288.

Trim and millwork we install

Trim is the detail that makes a house look finished. In Angleton we replace thin builder baseboards with taller profiles, add crown that suits the ceiling height, case doors and windows, and build wainscoting, board-and-batten and beamed or coffered ceilings. In older homes we match existing profiles so new work blends in; in newer homes we help pick a consistent profile family so every room reads as one house.

Because we also build cabinets, trim and casework are planned together — crown that wraps cabinet tops cleanly, a fireplace surround that lines up with built-in bookcases, stair skirt boards that meet the baseboard without awkward transitions. Read more about custom trim installation.

All services in Angleton

Kitchens & Baths

Cabinetry & Built-Ins

Storage & Organization

Trim, Doors & Stairs

Surfaces & Lighting

Nearby communities

Brazoria County

Much of Brazoria County is low, flat and close to the Gulf, so humidity and salt air are constant factors. We use plywood boxes, sealed edges and durable finishes, and we pay attention to hardware selection in homes near the coast where corrosion is a concern. For homes in flood-prone areas, raised toe kicks and moisture-resistant materials in the lowest components can make recovery easier after high water.

See all of Brazoria County →

More on Angleton

Custom cabinets & remodeling in Angleton →

Questions from Angleton homeowners

Does Ace Kustoms work in Angleton?

Yes. Angleton is part of our regular service area in Brazoria County, along with nearby Richwood, Danbury, Lake Jackson, Clute. We schedule in-home measurements throughout the week and the estimate is free.

How do I get an estimate in Angleton?

Call (281) 660-3903, text us, or send the form on this page with a few photos and rough measurements. We will set up an in-home visit, measure the space and follow up with a written, itemized estimate.

What trim and finish carpentry do you install in Angleton?

Baseboards, door and window casing, crown molding, wainscoting and board-and-batten, coffered and beamed ceilings, built-in bookcases, mantels and stair trim. We match existing profiles in older homes and help pick new ones that suit the house.

Can you match trim and cabinets that are already in my home?

Usually, yes. We take profile samples and measurements on site, then mill or source matching pieces. For cabinets, we can build new boxes and doors to blend with existing runs or build a full replacement that is consistent throughout.

Trim & carpentry guides

Trim & Millwork · 8 min read

Cabinets & Trim in Angleton, Brazoria County